Full Text:   <4907>

CLC number: TM714

On-line Access: 2024-08-27

Received: 2023-10-17

Revision Accepted: 2024-05-08

Crosschecked: 0000-00-00

Cited: 6

Clicked: 7002

Citations:  Bibtex RefMan EndNote GB/T7714

-   Go to

Article info.
Open peer comments

Journal of Zhejiang University SCIENCE A 2007 Vol.8 No.10 P.1532-1542

http://doi.org/10.1631/jzus.2007.A1532


Modeling of D-STATCOM in distribution systems load flow


Author(s):  HOSSEINI Mehdi, SHAYANFAR Heidar Ali, FOTUHI-FIRUZABAD Mahmud

Affiliation(s):  Center of Excellence for Power System Automation and Operation, Department of Electrical Engineering, Iran University of Science & Technology, Narmak 16846-13114, Tehran, Iran; more

Corresponding email(s):   mehdi_hosseini@iust.ac.ir

Key Words:  Distribution system, D-STATCOM, Voltage compensation, Load flow


HOSSEINI Mehdi, SHAYANFAR Heidar Ali, FOTUHI-FIRUZABAD Mahmud. Modeling of D-STATCOM in distribution systems load flow[J]. Journal of Zhejiang University Science A, 2007, 8(10): 1532-1542.

@article{title="Modeling of D-STATCOM in distribution systems load flow",
author="HOSSEINI Mehdi, SHAYANFAR Heidar Ali, FOTUHI-FIRUZABAD Mahmud",
journal="Journal of Zhejiang University Science A",
volume="8",
number="10",
pages="1532-1542",
year="2007",
publisher="Zhejiang University Press & Springer",
doi="10.1631/jzus.2007.A1532"
}

%0 Journal Article
%T Modeling of D-STATCOM in distribution systems load flow
%A HOSSEINI Mehdi
%A SHAYANFAR Heidar Ali
%A FOTUHI-FIRUZABAD Mahmud
%J Journal of Zhejiang University SCIENCE A
%V 8
%N 10
%P 1532-1542
%@ 1673-565X
%D 2007
%I Zhejiang University Press & Springer
%DOI 10.1631/jzus.2007.A1532

TY - JOUR
T1 - Modeling of D-STATCOM in distribution systems load flow
A1 - HOSSEINI Mehdi
A1 - SHAYANFAR Heidar Ali
A1 - FOTUHI-FIRUZABAD Mahmud
J0 - Journal of Zhejiang University Science A
VL - 8
IS - 10
SP - 1532
EP - 1542
%@ 1673-565X
Y1 - 2007
PB - Zhejiang University Press & Springer
ER -
DOI - 10.1631/jzus.2007.A1532


Abstract: 
This paper presents modeling of Distribution STATCOM (d-STATCOM) in load flow calculations for the steady-state voltage compensation. An accurate model for d-STATCOM is derived to use in load flow calculations. The rating of this device as well as the direction of required reactive power injection for voltage compensation in the desired value (1 p.u.) is derived and discussed analytically and mathematically by the phasor diagram method. Furthermore, an efficient method for node and line identification used in load flow calculations is presented. The validity of the proposed model is examined by using two standard distribution systems consisting of 33 and 69 nodes, respectively. The best location of d-STATCOM for under voltage problem mitigation approach in the distribution networks is determined. The results validate the proposed model for d-STATCOM in large distribution systems.

Darkslateblue:Affiliate; Royal Blue:Author; Turquoise:Article

Reference

[1] Baran, M.E., Wu, F.F., 1989a. Optimal capacitor placement on radial distribution systems. IEEE Trans. on Power Delivery, 4(1):725-732.

[2] Baran, M.E., Wu, F.F., 1989b. Network reconfiguration in distribution systems for loss reduction and load balancing. IEEE Trans. on Power Delivery, 4(2):1401-1407.

[3] Bishop, M.T., Foster, J.D., Down, D.A., 1994. The Application of Single-phase Voltage Regulators on Three-phase Distribution Systems. The 38th Annual Conf. on Rural Electric Power, p.C2/1-C2/7.

[4] Blazic, B., Papic, I., 2004. A new mathematical model and control of D-StatCom for operation under unbalanced conditions. Electric Power Systems Research, 72:279-287.

[5] Ghosh, S., Das, D., 1999. Method for load-flow solution of radial distribution networks. IEE Proc.-Gener. Transm. Distrib., 146(6):641-648.

[6] Gu, Z., Rizy, D.T., 1996. Neural networks for combined control of capacitor banks and voltage regulators in distribution systems. IEEE Trans. on Power Delivery, 11:1921-1928.

[7] Haque, M.H., 1996. Efficient load flow method for distribution systems with radial or meshed configuration. IEE Proc.-Gener. Transm. Distrib., 143(1):33-38.

[8] Haque, M.H., 2001. Compensation of Distribution System Voltage Sag by DVR and D-STATCOM. IEEE Porto Power Tech. Conf., 1(5):223-228.

[9] Kojovic, L.A., 2006. Coordination of Distributed Generation and Step Voltage Regulator Operations for Improved Distribution System Voltage Regulation. IEEE Power Engineering Society General Meeting, p.232-237.

[10] Ma, J., Xu, J., Wang, S., Lin, X., 2002. Calculation and Analysis for Line Losses in Distribution Network. Int. Conf. on Power System Technology, p.2537-2541.

[11] Mariun, N., Masdi, H., Bashi, S.M., Mohamed, S., Yusuf, S., 2006. Design of a Prototype D-STATCOM Using DSP Controller for Voltage Sag Mitigation. IEEE Power India Conf., p.61-66.

[12] Masdi, H., Mariun, N., Mahmud, S., Mohamed, A., Yusuf, S., 2004. Design of a Prototype D-STATCOM for Voltage Sag Mitigation. National Power and Energy Conf., p.61-66.

[13] Ramsay, S.M., Cronin, P.E., Nelson, R.J., Bian, J., Menendez, F.E., 1996. Using Distribution Static Compensators (D-STATCOMs) to Extend the Capability of Voltage-limited Distribution Feeders. The 39th Annual Conf. on Rural Electric Power, p.18-24.

[14] Sensarma, P.S., Padiyar, K.R., Ramanarayanan, V., 2001. Analysis and performance evaluation of a Distribution STATCOM for compensating voltage fluctuations. IEEE Trans. on Power Delivery, 16:259-264.

[15] Xu, S., Song, Q., Zhu, Y., Liu, W., 2005. Development of a D-STATCOM Prototype Based on Cascade Inverter with Isolation Transformer for Unbalanced Load Compensation. IEEE Int. Conf. on Industrial Technology, p.1051-1056.

Open peer comments: Debate/Discuss/Question/Opinion

<1>

Please provide your name, email address and a comment





Journal of Zhejiang University-SCIENCE, 38 Zheda Road, Hangzhou 310027, China
Tel: +86-571-87952783; E-mail: cjzhang@zju.edu.cn
Copyright © 2000 - 2024 Journal of Zhejiang University-SCIENCE