References
[1] Charoensuk, J., Lapirattanakun, A., 2011. On flame stability, temperature distribution and burnout of air-staged porous media combustor firing LPG with different porosity and excess air.
Applied Thermal Engineering, 31(16):3125-3141.

[2] Dobrego, K.V., Kozlov, I.M., Zhdanok, S.A., Gnesdilov, N.N., 2001. Modeling of diffusion filtration combustion radiative burner.
International Journal of Heat and Mass Transfer, 44(17):3265-3272.

[3] Howell, J.R., Hall, M.J., Ellzey, J.L., 1996. Combustion of hydrocarbon fuels within porous inert media.
Progress in Energy and Combustion Science, 22(2):121-145.

[4] Jugjai, S., Sawananon, A., 2004. The surface combustor-heater with cyclic flow reversal combustion embedded with water tube bank.
Fuel, 83(17-18):2369-2379.

[5] Kamal, M.M., Mohamad, A.A., 2005. Enhanced radiation output from foam burners operating with a nonpremixed flame.
Combustion and Flame, 140(3):233-248.

[6] Kamal, M.M., Mohamad, A.A., 2006. Combustion in porous media.
Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 220(5):487-508.

[7] Li, G.N., Zhou, H., Cen, K.F., 2008. Emission characteristics and combustion instabilities in an oxy-fuel swirl-stabilized combustor.
Journal of Zhejiang University-SCIENCE A, 9(11):1582-1589.

[8] Masashi, K., Toshiaki, H., 1998. The Scientific and Technology of Combustion Highly Preheated Air.
27th Symposium (International) on Combustion/The Combustion Institute, 27(2):3135-3146.

[9] Mathis, W.M., Ellzey, J.L., 2005. Flame stabilization, operating range, and emissions for a methane/air porous burner.
Combustion Science and Technology, 177(5):1323-1338.

[10] Michael, F., 2001. Low NO
x
combustion technologies for high temperature applications.
Energy Conversion and Management, 42(15):1919-1935.

[11] Mital, R., Gore, J.P., Viskanta, R., 1998. A radiation efficiency measurement procedure for gas-fired radiant burners.
Experimental Heat Transfer, 11(1):3-21.

[12] Muhad, R.M.N., Abdullah, M.Z., Mujeebu, M.A., Bakar, M.A.A., Zakaria, R., Mohamad, A.A., 2011. The development and performance analysis of partially premixed LPG porous medium combustor.
Energy Sources, Part A: Recovery, Utilization, and Environmental Effects, 33(13):1260-1270.

[13] Mujeebu, M.A., Abdullah, M.Z., Bakar, M.A.A., Mohamad, A.A., Abdullah, M.K., 2009. Applications of porous media combustion technology–review.
Applied Energy, 86(9):1365-1375.

[14] Mujeebu, M.A., Abdullah, M.Z., Bakar, M.A.A., Mohamad, A.A., Muhad, R.M.N., Abdullah, M.K., 2009. Combustion in porous media and its applications–A comprehensive survey.
Journal of Environmental Management, 90(8):2287-2312.

[15] Mujeebu, M.A., Abdullah, M.Z., Bakar, M.A.A., Mohamad, A.A., 2011. A mesoscale premixed LPG burner with surface combustion in porous ceramic foam.
Energy Sources, Part A: Recovery, Utilization, and Environmental Effects, 34(1):9-18.

[16] Wood, S., Harris, A.T., 2008. Porous burners for lean-burn applications.
Progress in Energy and Combustion Science, 34(5):667-684.

[17] Smucker, M.T., Ellzey, J.L., 2004. Computational and experimental study of a two-section porous burner.
Combustion Science and Technology, 176(8):1171-1189.

[18] Suzukawa, Y., Sugiyama, S., Hino, Y., Ishioka, M., Mori, I., 1997. Heat transfer improvement and NO
x
reduction by highly preheated air combustion.
Energy Conversion and Management, 38(10-13):1061-1071.

[19] Tarokh, A., Mohamad, A.A., 2009. Non-premixed CH
4 Combustion in a Porous Media.
, Proceedings of the ASME International Mechanical Engineering Congress & Exposition, Florida, USA, :
[20] Wang, G., Luo, D., Huang, H., 2011. Characteristics on Temperature Profiles of No-premixed Combustion in Porous Media.
, Power and Energy Engineering Conference (APPEEC), Asia-Pacific, Wuhan, China, 1-4. :1-4.

Open peer comments: Debate/Discuss/Question/Opinion
<1>